Mp-pumps PETROLEUM SELF-PRIMING 30, 40 INSTRUCTION Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pompes Mp-pumps PETROLEUM SELF-PRIMING 30, 40 INSTRUCTION. MP Pumps PETROLEUM SELF-PRIMING 30, 40 INSTRUCTION User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 3
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
SIZE: 30 AND 40
next use.
Do not install a piping system that does Do not continue to operate the pumping
not allow for any flex due to expansion from system when unusual noise or vibration
Do not allow severe temperature changes Do not perform service or maintenance
pumping system.
Drain pump completely before switching Do not mount pump in conditions that
flanges.
PO : Diesel, Biodiesel
and Fuel Oil
PG : Gasoline, Kerosene,
AV Gas, and Jet Fuels.
PE : Ethanol and E-85
PRINTED IN THE U.S.A.
pressurized or hot.
FORM 3075-A (6/08)
Do not continue to operate the pumping
system when a known leak exists or the
system starts to smoke.
WARNING!
to occur in a short time period within the when the pumping system is
Do not operate the pump in a manner that
it was not intended to be used.
heat generated by the pumping system.
Read this bulletin in full before installing, operating or servicing this pump. If any of the warnings
of this bulletin are ignored serious injury or death could occur.
MODELS:
This pump was designed to handle volatile and flammable fluids. To reduce the risk of
fire or explosion keep pump in well ventilated area free of explosive atmosphere. Do
not smoke where there is fuel being handled, also keep away from any sparks or open
flame. Do not operate pump with either the suction or discharge valves fully closed
as this will over heat the pump. If pump becomes overheated allow to cool before
occurs.
fuel type that is to be pumped. high piping loads exist on the pump
PETROLEUM SELF-PRIMING CENTRIFUGAL PUMPS
INSTRUCTION BULLETIN
Vue de la page 0
1 2 3

Résumé du contenu

Page 1 - WARNING!

SIZE: 30 AND 40next use.Do not install a piping system that does Do not continue to operate the pumpingnot allow for any flex due to expansion from

Page 2 - INSTRUCTION BULLETIN

It is important that this Instruction Bulletin be read carefully to fully familiarize yourself with the pumpassembly arrangement. The instructions

Page 3 - FORM 3075-A (6/08)

This pump is equipped with a self-lubricatedthe seal. shaft seal. The self-lubricated seal is lubricated by the liquid in the pump. If the pump is to

Commentaires sur ces manuels

Pas de commentaire