Mp-pumps HTO 120 INSTALL Manuel d'utilisateur télécharger pdf

FORM 3061-B

PRINTED IN U.S.A. (1-07)

MP PUMPS HTO SERIES

This bulletin must be read completely before installing, operating, or servicing the pump.

HTO 120 INSTALLATION AND SERVICE INSTRUCTIONS

WARNING:

If any of the items listed below are violated, serious injury or death from burns caused

by hot oil may occur.

• DO NOT perform service or maintenance when

the pumping system is pressurized or hot -

serious injury or death from burns caused by hot

oil may occur.

•

DO NOT operate the pump in a manner that it

was not intended to be use.

•

DO NOT install for use in an open environment

where people are present.

•

DO NOT install in a rigid piping system that

does not allow the pipe to expand and cause the

pump to be strained.

•

DO NOT continue to operate the pumping

system when a known leak exists or the system

continues to smoke.

•

DO NOT continue to operate the pump when

unusual noise or vibration occurs.

•

DO NOT install or use near water where the

pumping system may come into contact with

water or is splashed by water.

• DO NOT operate beyond the pressure or

temperature limits stated in the product

literature, see form 9050.

•

DO NOT allow severe temperature

changes to occur in a short time period

within the pumping system.

•

DO NOT mix dif

ferent types or grades of oil

within the oil system.

•

DO NOT use an oil that is not a

recommended heat transfer oil by the

manufacturer.

•

DO NOT exceed the maximum oil

temperature rated by the oil manufacturer

at the hottest point in the pumping system.

•

DO NOT mount the pump such that high

piping loads exist on the pump flanges.

1 2 3 4

Résumé du contenu

Page 1 - FORM 3061-B

FORM 3061-BPRINTED IN U.S.A. (1-07)MP PUMPS HTO SERIESThis bulletin must be read completely before installing, operating, or servicing the pump.HTO

Page 2 - INSTALLATION AND START-UP

MP PUMPS HTO SERIESAPPLICATION AND INSTALLATION INSTRUCTIONSINSTALLATION1. The pump must be installed in a horizontal shaftposition.2. The housing m

Page 3 - OPERATION AND MAINTENANCE

MP PUMPS HTO SERIESOPERATION AND MAINTENANCEThermal oil vapors leaking from a system can behighly flammable.Any system leak should be repaired immed

Page 4

MP PUMPS HTO SERIESHTO 120 ASSEMBLY INSTRUCTIONSFORM 3061-BPRINTED IN U.S.A. (1-07)1. Assemble drive sleeve #11 (29781), impeller#1 (29770) and nut

Commentaires sur ces manuels

Pas de commentaire

Mp-pumps HTO 120 INSTALL Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pompes Mp-pumps HTO 120 INSTALL. MP Pumps HTO 120 INSTALL User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pompes Mp-pumps HTO 120 INSTALL