Mp-pumps PETROLEUM SELF-PRIMING 5, 8, 10, 15 INSTRUCTION Manuel d'utilisateur télécharger pdf

Do not install a piping system that does Do not continue to operate the pumping

not allow for any flex due to expansion from system when unusual noise or vibration

Do not allow severe temperature changes Do not perform service or maintenance

pumping system.

Drain pump completely before switching Do not mount pump in conditions that high

PO Biodiesel, Diesel and Fuel Oil.

PG Gasoline, Kerosene, Avgas

Jet A and JP 8 Fuel.

PE Ethanol and E-85.

occurs.

Do not continue to operate the pumping

system when a known leak exists or the

system starts to smoke.

or hot.

FORM 3074-A (2/08)

fuel type that is to be pumped. piping loads exist on the pump flanges.

WARNING!

to occur in a short time period within the when the pumping system is pressurized

Do not operate the pump in a manner that

it was not intended to be used.

heat generated by the pumping system.

PRINTED IN THE U.S.A.

MODELS:

This pump was designed to handle volatile and flammable fluids. To reduce the risk of fire or

explosion keep pump in well ventilated area free of explosive atmosphere. Do not smoke where

the fuel is being handled, also keep away from any sparks or open flame. Do not operate pump

with either the suction or discharge valves fully closed as this will over heat the pump. If pump

becomes overheated allow to cool before next use.

PETROLEUM SELF-PRIMING CENTRIFUGAL PUMPS

INSTRUCTION BULLETIN

Read this bulletin in full before installing, operating or servicing this pump. If any of the warnings of

this bulletin are ignored serious injury or death could occur.

1 2 3 4

Résumé du contenu

Page 1 - WARNING!

Do not install a piping system that does Do not continue to operate the pumpingnot allow for any flex due to expansion from system when unusual nois

Page 2 - INSTRUCTION BULLETIN

unlock impeller drive sleeve from drive shaft.The impeller on the PO,PG,PE 10 and 15 has 5. Worn impeller - too much clearance 4. Seal worn an

Page 3 - REASSEMBLY

When replacing wear plate, be sure to usenew gaskets under acorn nuts to sealagainst air leaking in on suction sideduring priming cycle.and require re

Page 4 - FORM 3074-A (2/08)

The assembly of impeller and seal to the driveshaft should take place as soon as the bellowsassembly is slipped on the impeller sleeve soas to avoid b

Commentaires sur ces manuels

Pas de commentaire

Mp-pumps PETROLEUM SELF-PRIMING 5, 8, 10, 15 INSTRUCTION Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pompes Mp-pumps PETROLEUM SELF-PRIMING 5, 8, 10, 15 INSTRUCTION. MP Pumps PETROLEUM SELF-PRIMING 5, 8, 10, 15 INSTRUCTION User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pompes Mp-pumps PETROLEUM SELF-PRIMING 5, 8, 10, 15 INSTRUCTION