Mp-pumps FRX-75 SP INSTALL Manuel d'utilisateur télécharger pdf

Model FRX 75-SP is a high performance

selfpriming 316 stainless steel centrifugal pump.

The pump is ideal for marine, industrial,

agricultural or commercial applications where

suction lift is required.

The FRX 75-SP model features all 316 stainless

steel components for superior corrosion

resistance when pumping chemical compounds.

A carbon / ceramic / viton bellows seal is

standard. Ports are 3/4" with 1/8" NPT fill port.

The FRX 75-SP model is capable of 12 foot suc-

tion lift (3450 rpm).

FORM 3807A (08-06)

FRX 75-SP STAINLESS STEEL CENTRIFUGAL PUMP

INSTALLATION, OPERATION, AND REPAIR MANUAL

GENERAL SAFETY INFORMATION:

THE FOLLOWING WARNINGS ARE USED TO NOTIFY AND ADVISE THE USER OF THIS PRODUCT OF

PROCEDURES THAT MAY BE DANGEROUS TO THE USER OR RESULT IN DAMAGE TO THE PRODUCT.

THIS BULLETIN MUST BE READ COMPLETELY BEFORE INSTALLING, OPERATING, OR SERVICING,

THE PUMP.

INSTALLATION:

For optimum performance, place the pump as close to the liquid as possible to minimize suction

lift. For best results, the pump should be installed no more than 10 feet above the liquid supply.

The motor is splash resistant, not submersible, and should be located in a dry environment.

• DO NOT perform service or maintenance

when the pumping system is pressurized.

Injury or death may occur.

• DO NOT operate the pump in a manner

that it was not intended to be used.

• DO NOT mount the pump such that high

piping loads exist on the pump flanges, or

in a rigid piping system that does not allow

the pipe to expand and cause the pump to

be strained.

• DO NOT continue to operate the pumping

system when a known leak exists.

• DO NOT continue to operate the pump

when unusual noise or vibration occurs.

• DO NOT operate beyond the pressure or

temperature limits stated in the product

literature. See Form 8110.

• DO NOT allow severe temperature changes

to occur in a short time period within the

pumping system.

Patent Pending

1 2

FORM 3807A (08-06) 1

Résumé du contenu

Page 1 - FORM 3807A (08-06)

Model FRX 75-SP is a high performance selfpriming 316 stainless steel centrifugal pump.The pump is ideal for marine, industrial, agricultural or comme

Page 2

®FORM 3807A (08-06)PIPING/MOUNTING:The pump inlet and outlet has 3/4" pipe connections. Use pipe sealant on the threads and other connections. Th

Commentaires sur ces manuels

Pas de commentaire

Mp-pumps FRX-75 SP INSTALL Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pompes Mp-pumps FRX-75 SP INSTALL. MP Pumps FRX-75 SP INSTALL User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pompes Mp-pumps FRX-75 SP INSTALL