Mp-pumps FRX-100 316 INSTALL Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pompes Mp-pumps FRX-100 316 INSTALL. MP Pumps FRX-100 316 INSTALL User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
FRX100 316 STAINLESS STEEL CENTRIFUGAL PUMP
INSTALLATION, OPERATION, AND REPAIR MANUAL
GENERAL SAFETY INFORMATION
:
THE FOLLOWING WARNINGS ARE USED TO NOTIFY AND ADVISE THE USER OF THIS PRODUCT OF
PROCEDURES THAT MAY BE DANGEROUS TO THE USER OR RESULT IN DAMAGE TO THE PRODUCT.
THIS BULLETIN MUST BE READ COMPLETELY BEFORE INSTALLING, OPERATING, OR SERVICING,
THE PUMP.
DO NOT
perform service or maintenance
when the pumping system is pressurized.
Injury or death may occur.
DO NOT
operate the pump in a manner
that it was not intended to be used.
DO NOT
mount the pump such that high
piping loads exist on the pump flanges, or
in a rigid piping system that does not allow
the pipe to expand and cause the pump to
be strained.
INSTALLATION
:
Install the pump where the inlet is below the liquid level. A valve may be used to isolate the
pump for service. The pump is not self-priming and needs the inlet to be flooded at start-up.
The motor is splash resistant, not submersible, and should be located in a dry environment.
FRX 100 is a high performance 316 stainless steel
centrifugal pump. Its uses are marine, commercial,
and industrial transfer of chemicals or potable water.
All pump parts are 316 stainless for superior corro-
sion resistance when pumping chemical com-
pounds. A carbon, ceramic, viton, bellows shaft seal is
standard. The FRX 100 is designed with 1 inch NPT
porting and the pump rotation can be achieved in 90 de-
gree increments.
FORM 3808A (03-07)
DO NOT
continue to operate the pumping
system when a known leak exists.
DO NOT
continue to operate the pump
when unusual noise or vibration occurs.
DO NOT
operate beyond the pressure or
temperature limits stated in the product
literature. See Form 8110.
DO NOT
allow severe temperature changes
to occur in a short time period within the
pumping system.
Vue de la page 0
1 2

Résumé du contenu

Page 1 - FORM 3808A (03-07)

FRX100 316 STAINLESS STEEL CENTRIFUGAL PUMPINSTALLATION, OPERATION, AND REPAIR MANUALGENERAL SAFETY INFORMATION:THE FOLLOWING WARNINGS ARE USED TO NOT

Page 2 - FORM 3808A (03-07)

PIPING/MOUNTING:The pump inlet and outlet has 1 pipe connections. Usepipe sealant on the threads and other connections. Thebase does not require direc

Commentaires sur ces manuels

Pas de commentaire